Starting the Vehicle

1. Aim the RKE transmitter at the vehicle.

2. Press and release 3. Immediately after completing Step 2, press and hold.

3. Immediately after completing Step 2, press and hold When the vehicle starts, the parking lamps will turn on and remain on as long until the turn signal lamps flash.

When the vehicle starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

Canceling a Remote Start

To cancel a remote start:

  • Aim the RKE transmitter at the vehicle and press and hold Turn on the hazard warning flashers. until the parking lamps turn off.
  • Turn on the hazard warning flashers.
  • Turn the ignition on and then back off.

See Remote Vehicle Start  .

    See also:

    Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire (Not Punctured)
    To use the air compressor to inflate a tire with air only and not sealant: If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place. Turn on the hazard wa ...

    Ignition Positions
    The vehicle has an electronic keyless ignition with pushbutton start. Pressing the button cycles it through three modes, ACC/ACCESSORY, ON/RUN/START and STOPPING THE ENGINE/OFF. If the push ...

    Automatic Transmission
    Driver Shift Control (DSC) or Tap Shift Driver Shift Control (DSC) allows shifting an automatic transmission similar to a manual transmission. DSC can be enabled through the shift lever or t ...