Wireless Headphones
The two wireless headphones included with the Headrest DVD RSE system will only work with the Headrest DVD RSE system and are marked for channel 3 and 4. The wireless headphones must be used within a line of sight of the transmitter that is located above the video display screen.
3-4 Channel Selector: This is located on the right earpiece. Either Channel 3 or 4 can be selected with the channel selector. The driver side monitor is designated as Channel 3, and the passenger side as Channel 4. Set the channel selector switch according to the video display screen being viewed. The message, “To listen to this monitor tune your headphones to Channel 3 (or 4)” displays for five seconds then disappears when the video display screen is turned on.
OFF/ON (Power): Turn the power switch located on the earpiece to turn the wireless headphones on or off. Each headphone has a light to indicate ON. If the light does not come on, the batteries may need to be replaced. See “Battery Replacement” under Rear Seat Entertainment (RSE) System (Headrest DVD) or Rear Seat Entertainment (RSE) System (Overhead) for more information.
The headphones shut off automatically if the RSE system is turned off or if the headphones are out of range of the transmitter for more than three minutes.
VOL (Volume): Use to adjust the
volume on the headphones.
Notice: Do not store the headphones in heat or direct sunlight. This could damage the headphones and repairs will not be covered by the warranty. Storage in extreme cold can weaken the batteries. Keep the headphones stored in a cool, dry place.
See also:
Low-Beam Headlamps/Daytime Running Lamps (DRL), High-Beam Headlamps (Base)
1. From the back side of the headlamp assembly, remove the top cap to
replace the low-beam headlamp/DRL bulb.
2. From the back side of the headlamp assembly, remove the bottom cap to
repl ...
Fuels in Foreign
Countries
Never use leaded gasoline or any
other fuel not recommended in the
previous text on fuel. Costly repairs
caused by use of improper fuel
would not be covered by the vehicle
warranty.
To chec ...
Universal Remote System Operation
Press and hold the appropriate button for at least half of a second. The indicator
light will come on while the signal is being transmitted.
Reprogramming Universal Home Remote Buttons
Any of the ...