Hood
To open the hood:
1. Pull the handle with this symbol on it. It is located inside the vehicle to the lower left of the steering wheel.
2. Then go to the front of the vehicle and locate the secondary hood release, near the center of the grille.
3. Push the secondary hood release to the right.
4. Lift the hood.
Before closing the hood, be sure all the filler caps are on properly. Then bring the hood from full open to within 152mm (6 in) from the closed position, pause, then push the front center of the hood with a swift, firm motion to fully close the hood.
See also:
Manual Mode
Driver Shift Control (DSC)
Notice: Driving with the engine at a high rpm without upshifting while
using Driver Shift Control (DSC), could damage the vehicle.
Always upshift when necessary while u ...
Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located under the storage tray on the
driver side trim panel (over the rear wheelhouse).
To access the tire sealant and compressor kit:
1. Remove the tray ...
Recommended Fluids, Lubricants, and Parts
Recommended Fluids and Lubricants
Maintenance Replacement Parts
Replacement parts identified below by name, part number, or specification can
be obtained from your dealer.
...