Voice Recognition
The Bluetooth system uses voice recognition to interpret voice commands to dial phone numbers and name tags.
For additional information say “Help” while you are in a voice recognition menu.
Noise: Keep interior noise levels to a minimum. The system may not recognize voice commands if there is too much background noise.
When to Speak: A short tone sounds after the system responds indicating when it is waiting for a voice command. Wait until the tone and then speak.
How to Speak: Speak clearly in a calm and natural voice.
See also:
Driver Information Center (DIC)
The DIC display is located in the center of the instrument panel cluster. It
shows the status of many vehicle systems. The controls for the DIC are located
on the turn signal lever.
A. SET/CL ...
SBZA Detection Zones
The SBZA sensor covers a zone of approximately one lane over from both sides
of the vehicle, 3.5m (11 ft). This zone starts at each side mirror and goes back
approximately 5.0m(16 ft). The heigh ...
Conditions in Which Remote Start Will Not Work
The remote start will not operate if any of the following occur:
- The ignition is in any mode other than OFF.
- The transmitter is in the vehicle.
- The hood is not closed.
- The hazard warning ...