Voice Pass-Thru

Voice Pass-Thru allows access to the voice recognition commands on the cell phone. See the cell phone manufacturer's user guide to see if the cell phone supports this feature.

This feature can be used to verbally access contacts stored in the cell phone.

1. Press and hold two seconds. For vehicles with a for two seconds. For vehicles with a navigation system say “Hands Free” after the tone.

2. Say “Bluetooth.” This command can be skipped.

3. Say “Voice.” The system responds with “OK, accessing <phone name>.” . The cell phone's normal prompt messages will go through their cycle according to the phone's operating instructions.

    See also:

    Adding Washer Fluid
    The vehicle has a low washer fluid message on the DIC that comes on when the washer fluid is low. The message is displayed for 15 seconds at the start of each ignition cycle. When the WASHER FLUID ...

    Flash-to-Pass
    Use your high-beam headlamps to signal to a driver in front that you want to pass. It works even if the headlamps are in the automatic position. To use it, pull the turn signal lever toward you, th ...

    Shutting the Engine Off After a Remote Start
    To manually shut off the engine after a remote start, do any of the following: - Press until the parking lamps turn off. - Turn on the hazard warning flashers. - Turn the ignition switch o ...